This video displays how-to build a Stratco Outback Flat Attached Veranda, Patio, Carport or Awning from start to finish. Hey all, I decided to take advantage of the weather and build a carport on the side of the shop.
Then you can flash the roof to the vertical wall and cover this flashing with the second layer of siding.
Are you considering re-routing the downspout from your main garage roof so it doesn't wash out the car port area? With that embankment, I am thinking some well routed gutters and down spouts will be needed in your area. Autoist - Yes, but I think that it reports the usage back to Puget Sound Energy down the wire so they never come out unless there is a problem. For this particular woodworking project, the county required the homeowner to pour a slab of cement no larger than 200 square feet. We screwed in the osb sheet material to the framing accordingly in preparation for the lap siding and roofing. Please note that the prices here are not guaranteed and may change at any given point in time.


You are currently viewing our boards as a guest which gives you limited access to view most discussions and access our other features. I nailed it level with 3.5 16d nails and then added the 5" ledgerboard screws from QuikTite. When you build a storage shed, you need to make sure that the area that your home is located doesn’t have any kind of restrictions or regulations of any kind. Once all the permits, inspections and plans were good to go, I started with the exterior walls. This included two 2 x 8 x 16 boards attached to each other to make a beam to support the rafters, since it wasn’t going to be attached to the home. I was able to measure and cut each 2 x 6 rafter and have the bottom of the board rest on each stud for additional support. By joining our free community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features.
I have already applied a liberal amount of sealant to the joint where the roof sheeting meets the wall. Essentially moving out the dirt and creating more gravel area, then putting up a rock wall and building up a garden area.


You may need a building permit, especially if you’re thinking about attaching a shed to your home. Now that the trim work is cut and ready, we now begin to nail in the lap siding starting at the bottom.
If you have any problems with the registration process or your account login, please contact contact us. I plan on using the 3x5 flashing with adhesive to the wall and then a 6.5" Hardie Plank board heavily caulked to the wall to keep water from infiltrating.
After a few days of framing, trim and siding, this storage shed is nearly to it’s completion.



Livable shed with loft kits
Outdoor patio cover kits
Garage cabinets in phoenix arizona
Storage units for sale greenville sc


Comments to «Build a shed attached to house»

  1. OnlyForYou on 16.01.2014 at 18:22:42
    The place you'll be able to keep goods and hills.
  2. parin_iz_baku on 16.01.2014 at 19:45:37
    With building paper and colorsteel roofing with see one.