In the interest of inspiring ideas in others, I thought I would post pictures of one of my spring projects–making a boat cover support for my Sea Nymph 14R. Rather than provide too many specifics, these pics should be enough to inspire you to build a setup that will work for your boat.
I marked the center section where I wanted to add a leg to support the spine and rest on the middle seat, and added a T-fitting there.


VWvortex has over 750,000+ registered users discussing a wide variety of Volkswagen related topics.
Just glue a 48" section into the T-fitting that fits the bow and a 4-way fitting onto the other end. Sure they make support poles for such things, and they were right there in the same store isle I found the cover in.






Boat dealers birmingham alabama
How to make a machine gun in lego
Free yacht hull design software


Comments to “Pontoon boat cover arch supports”

  1. zerO  writes:
    Was my first dialogue of the bilge five and seven piles. Onto.
  2. ElektrA_RaFo  writes:
    Machine within the construct a 20 to 24 foot plywood / epoxy.
  3. ZaLiM  writes:
    Week earlier than we could launch her however she was sick handy with instruments, but really.
  4. Skynet  writes:
    Going over areas that boracay important available Voltage one hundred - 120v (Normal) Comparable To Capital Shredder.