Woodworking plans for jewelry boxes large,how to build a wood gun cabinet video,best coffee table books 2014 15 - Test Out

If you need a last-minute gift idea and you have some beautiful small boards on hand, you have all you need to create this box. I chose yellowheart from Brazil and padauk from West Africa for their contrasting hues, but any striking combination of hardwoods will do nicely. Joint one side of each of the yellowheart boards to create flat surfaces, then plane them down to the thicknesses listed. Shape the curve of the leg using a bandsaw, then sand the cut surfaces using a belt sander.
Next, scribe a line along the curved portion of the leg 1?4" in from the edge on both the sides and faces of the leg. While you’re still near the bandsaw, cut a small scallop out of the back edges of the bottoms of the legs.


Glue up the four legs and four sides, then prepare a pattern for cutting the cork that will line the bottom of the box (not pictured).
Before you apply any finish, use tape to mask the places where the fixed part of the lid fastens to the back of the box. For a quick and easy finish, I chose a water-based, low-odour, clear matte spray in an aerosol can. As you work, saw pieces from the board in sequence to ensure the grain is visually consistent as it runs around the corners of the box. Trace the upside-down box on a thin piece of cardboard (cereal boxes work well), cut it out and transfer the shape to your cork sheet before setting it aside. A lovely little gift that goes together quickly while helping you use up nice leftover stock you don’t have the heart to toss out.


Orient the wood so the surface that will become the inside face of the leg rides against the fence. These support the padauk bottom, which is a little smaller than the opening to allow for seasonal expansion.



Wooden house ideas minecraft youtuber
Build in cupboards in cape town 806




Comments