How to make sliding doors for a cupboard,woodworth and schlosberg experimental psychology,black and white coffee table sets,woodworking free plans 00 - Review

01.05.2015
Once you have dialed in the width of the dado set, depth of cut, and location, using a scrap piece, the real door goes against the stop.
I love sliding doors and lids, partly because it is an excuse to make these elegant handles in one simple step on the tablesaw (plus a bit of sanding). You basically set up a dado set at the height and width you want the handles to be, clamp a stop to the table, and make the handle by tilting the door down onto the dado set in one shot. I have a trick for clamping the stop to the tablesaw, tacking a lip onto the end so I can clamp against the rip fence instead of down against the cast-iron table, which can be tricky. After that, you just turn on the saw, sit the bottom of the door against the stop, and tip the front edge down. You will have to switch the whole setup to the other side of the rip fance to cut a handle on the other edge of the door or doors. The handles are centered vertically on the doors, but I didn't want to take a chance and pivot off both the top and bottom of the door. If you center the handle vertically on all doors, why would you have to move the entire setup to the other side of the table saw fence?
Over at Timber and Lace, Marci and hubby get creative with scrap timber and a hanging rail to make sliding barn doors to close off an alcove for Marci's craft room.


The plywood panels were layed out on the floor of the garage and the reclaimed wood nailed onto it. After fastening down the first layer of reclaimed timber to the plywood panels, build a frame around the edge of the panel for effect. To finish off the doors, use reclaimed timber to create the 'barn-style' effect on each door. A onetime fashion darling, now working out of rural Pennsylvania with her son and partner, J.
Check out more interesting categories: Consumer, Design, DIY, Educational, Entertainment, Featured DIYs, Furniture, Gadgets, Hack, Home, HOWTO, Misc, Projects.
Making the 8 handles on the 4 sliding doors is the easiest part, thanks to a neat trick with a dado set.
As you lower it slowly onto the spinning blades, be sure to also keep it snug against the rip fence. Touch it down flat on the table and immediately bring it back up, again keeping it snug against the rip fence for a clean cut. You'll need to make test cuts in some scrap to see how deep to go into the door, and how long a handle that makes.


Don't linger with the door agaunst the table, or you will get some burn marks inside the handle, which are a pain to sand off.
Before you move the stop, draw a pencil line along the bottom edge to help locate it after you change the setup.
You can use the plywood sheets as a guide to dry fit the various timber sections before nailing them down, so that you can pick the best pieces. Morgan used super thick industrial felt to sculpt dressing rooms and doors that hung from the ceiling. It might seem dangerous, but it isn't, as long as you are pivoting off a stop at the front edge of the door. The test cut will also tell you exactly how far from the stop that the handle will appear on the door, and verify that you have the rip fence in the right spot.



Kreg cabinet making booklet pdf bearbeiten
Wooden kitchen tablet holder nakkest?tte
Wooden cross patterns free 18


Comments to “How to make sliding doors for a cupboard”

  1. 0503610100 writes:
    Other sites whose collection of plans have the i used to be determined smaller.
  2. Ronaldinio writes:
    Completed constructing it a couple of months developed were too difficult, but small.