Toshiba laptop dc power plug,laptop power adapter holder,digital cable splitter power pass - You Shoud Know

26.11.2014

Our customer service department is prompt in replying to you the same day or the next working day. Alternatively you can also call our Toll free number 1800-850-9661 and for International Callers +1 (818) 334-5309. Assembling your Toshiba Satellite A665-S6050 laptop keyboard is also simple and straight forward. Today I explain how to repair damaged power connector also known as power jack in Toshiba Satellite L305 and L355 laptops. I will replace the original plastic jack with a generic metal jack purchased at RadioShack for about $3.
In order to access and repair the jack it’s necessary to disassemble the laptop and remove the top cover assembly. If you send your laptop with a damage like that to a repair shop, they will recommend replacing the jack harness and base assembly. Here’s my new replacement panel-mount jack which should last for a long time unlike the original Toshiba jack. Using a pocket knife remove plastic supports from the internal side of the base assembly, so the side where the new jack will be mounted is flat. The new jack is too long and if you install it as is, the top cover will not sit properly on the base. Remove the damaged DC jack from the case and cut off wires somewhere close to the jack base.
As you see, I soldered wires at a 90 degree angle to the jack so the top cover (and the right speaker) fits in. Remove plastic reinforcement walls so they do not touch the power jack when the cover is installed.
I think the new power jack is way more robust then the original one and should last for a long time.
This base is bigger than one in my previous example and you’ll have plenty of space for your modification. I had a problem like that but I didn’t repair laptop myself because it was under warranty. The Satellite L355D laptop has a larger case and fitting a new jack in should be a problem. The step-by-step instructions, right down to the case modification, were crystal clear, and spot-on.
Havnt finished the actual repair yet, have to get out of work and run to radio shack for the parts however, i did prep everything so all i have left is the soldiering and such of the new jack. If you reassembled a laptop and the screen doesn’t come on, the first you have to check is the memory modules.
I did the process as you detailed, but for some reason my laptop still isn’t charging! If no other ideas we are going to check with Toshiba on how much it would cost to fix without warranty, any idea how much this repair would cost?
We tried to do this mod and was looking great but when we went to turn it on the laptop was just makes some tapping sound, any ideas? If you soldered the new jack correctly but the laptop still not working, most likely it’s related to the motherboard.
Well, we did have trouble soldering the middle pin, it was kind of hard getting it to stick to that smooth surface. I used a multimeter to test if power was going through and it was so I guess it is now a motherboard problem. Could I like cut some notches or drill a hole on the middle pin for the solder to stick better on it cause I’m pretty sure if I open the laptop again it probably came off. As a temp repair, the locating lugs were not broken and I’ve rotated the existing socket thru 180 and refitted and put a brace section (modified an old desktop card blank cover) to provide support should she put too much pressure on the power lead when connecting. I just want to thank you very much, for putting these instructions online, i see that they have already been a huge success for many others, and i just finished on my satellite L355. But initially it was caused bc i accidently tripped over my charger and the power jack got displaced inside.
Is the battery problem being caused by the displaced power jack or is there something else? I have to push the cord in and put the computer in a weird position so it gets charged, which is very inconvient bc most of the time it goes back to battery. You’ll have to test the AC adapter with a voltmeter and find out if power cuts off when you move the cord.
So i tried to use my charger on a different toshiba laptop and it was causing the same problems, if u slightly moved it, it would go on battery. I also see the power jack inside the laptop displaced and pushed in, can that alone cause that problem too?


I have the same problem too but with mine it was broken since day 1 after i pulled it out of the box. I have had this same problem, bought an L305 in February (love the laptop, but probably wouldn’t have bought it if I had known about these issues) and had to have the port and keyboard replaced in late August. Thanks for the guidance – I went for a slightly different approach which involved simply glueing a small wedge of rubber to the side of the power socket so that the mini speaker mounted to the top cover fitted right next to power socket when re-assembled. There is still a little lateral movement but it doesn’t move in anymore and I avoided having to visit Radioshack or break out the soldering iron!
My power port is having the same problems a second time, though I’ve used the warranty to get it fixed the first time. My power connector has broken on my Toshiba L350 – bought in january 2009 and still under warranty. Now I see the power button working and I could tell that there is power reaching the machine although the screen DOSE NOT DISPLAY ANYTHING. Remove the top cover and check if the power goes to the motherboard through the DC harness. If the motherboard is getting power but there is no power light, most likely the motherboard is bad.
The maplin connector has 3 connectors so a multi meter helps to determine which is positive and which is negative. My girlfriend had a similar problem with her L305D the adapter was really loose so when she plugged in her adapter it wasn’t making a good connection. Thanks for a superb guide which gave me the confidence to tackle a job for which I was quoted ?100! You must have JavaScript enabled in your browser to utilize the functionality of this website.
Our experienced laptop repair technicians specialize in all makes and models of laptops and notebooks motherboard repair on component level. A: When you plug AC adapter, the laptop appears to be dead and there is no LED activity at all. A: If your laptop works fine for 10-15 minutes and then suddenly shuts down caused an application was started more demanding, most likely it experiences an overheating problem. ReviewsThere are no reviews yet, would you like to submit yours?Disclaimer: These are user reviews.
Follow our step-by-step guide which will help you go through the installation process with ease. It happens because one of the speakers (in Satellite L305D) is located very close to the DC jack. Again, the red wire is soldered to the lead in the center and the black on to the lead on the side.
I mailed it to a local authorized Toshiba center (Northwest Computer Support) and they replaced the bottom and power socket at no charge. I saw no point in getting it repaired with the same type of power jack which may or may not break again in 5 months.
After opening my nephew’s L355D, I noticed the jack and the base were both intact, and I was about to cement it back in. There are no clear signs of the motherboard being cracked, or any of that but I feel I may have to disassemble it completely to look at the motherboard. After I replaced the jack, it still did not charge so I cut open the power card close to the connector and discovered a loose solder on the ground wire in the power card.
I have the same problem my power jack has been displaced, but my laptop goes on battery with this problem, its as if my charger doesnt supply the electricity enough. It’s possible that you damaged the power cord when you tripped over the AC adapter but this is just a guess.
Apparently the power cord is damaged and when you move it you shorting wires inside the cord. Most like the jack is just dislocated because the jack housing is broken or the mounting bracket inside the case is broken. Plug in the AC adapter into the jack and test voltage at the terminals where the harness is connected to the motherboard.
I cannot tell if your adapter was bad or you soldered something incorrectly without looking at the laptop.
I’m sure whatever I did wrong was something pretty simple, as it is hard to go wrong with instructions that are this detailed. So I removed the top cover and carefully superglued the plastic adapter to the side of the laptop.
Then I converted the notebook to bluetooth by soldering a small BT dongle to a USB port so that the dongle is now located inside the machine.
Cost me less than ?10 including the dongle – and a couple hours sat in the kitchen instead of going down the pub!


Another symptom is power LED and battery charge LED start flickering when you wiggle the power cord or the AC adapter tip on the back or your laptop. Laptop overheating issues can cause several symptoms such as sudden shutdown failures or randomly appearing screen of deaths. You can replace the broken one with this new DC power jack without damaging the motherboard.
Once your order is shipped, you will be emailed the tracking information for your order’s shipment. Then I figured, for $3 and about an hour of time (and a large Dunkin’ Donuts coffee) I would save myself the hassle of most likely having to do this again, and, ultimately having to replace the jack assembly anyway. Im not really a electroincs guru, my knowledge goes thru high school electonics class, but what i am is a supporter or do it youself.
I was wondering how tight the socket is from new as i only have about 1mm of play up and down and about the same left to right with no movement in and out. I got a new power cord since the laptop was under warranty and now I have a much stronger power jack installed as well. I warned my wife several times that was going to eventually happen because she is not careful where she plugs in her laptop.
If (or maybe when) my own Toshiba’s power jack bites it, I have the parts on hand and waiting.
The ac input is now nice and solid and the adapter plugs in nicely with no play, but unfortunately there is no longer any power at all getting to the laptop so it wont turn on. There are 5 additional screws to remove at this stage and only two of the cables need to be disconnected. Meanwhile, you should realize that purchasing the DC Jack you need, repair your laptop, or whatever device you are working on is actually to save money for you. You can choose your preferred shipping method on the Order Information page during the checkout process.
I would, however, strongly recommend to anyone doing this procedure NOT to do this on the kitchen table with 2 curious cats running around. Since it will charge if pushed in hard enough, is this a power cord connector issue or the jack? She needs her laptop for her home business and was devastated when she realized it could take days or weeks not to mention the expense to have it fixed. Anyways, i googled and found your website and followed the instruction one by one and made it happen. I can plug it in, and I get the indicator light below the touchpad showing that it is charging, but the screen never comes on. If the power jack is not broken, we can resolder it on both sides of the motherboard, this will minimize movement when the adapter is plugged into it. I bought the parts to fix this with the co-axial solution, but am wondering if I might still have the same problem after doing this. I originally thought the socket was soldered directly to the board so any movement was bad news, but looking at the design i’m thinking that it might be normal. Researching the Internet for a repair service I found your instructions to dis-assemble the laptop and subsequently how to repair a broken jack. I can hear the fan, the hard drive spin-up, and the DVD accessing, but absolutely nothing on the screen. Once again, thank you for creating this web site and taking the time to help out many people you will never even meet.
I was just wondering if anybody else experienced this issue and if they did how they resolved it.
Doing the repair on a Satelite A-205a so far so good everything is matching up so add another to the list that this will work for. I ran out to Radio Shack to pick up the jack and within 3 hours of reading your instruction I had repaired my wife’s laptop. I also checked for power where the red and black wires connect to the laptop and had power. After about 8 or 9 seconds, the computer shuts itself off for about 3 seconds, then tries to boot again with the same result. I get the same problem with the unit unplugged if I hit the soft power button above the keyboard.



Numerology horoscope matching for marriage kannada
Psychic readings online for free viooz
Chinese horoscope 2014 aries

Categories: Numerology Birth Date



Comments to «Toshiba laptop dc power plug»

  1. CANNOT stop find out about life and its we're best.
  2. Out the books you will certainly pertain to understand the quantity system, which.
  3. Very few of these are good this.